I molded the CROWS from the Academy Stryker,
Then I looked at my Diescast ,
of the JGSDF Light Armored Vehicle (the Komatsu LAV )
from Kyosho and thought ....hmmmmmmm
so I drilled a hole in the roof
where I though a weapons pintle should go, and placed it there.
then I thought it over some more......
and thought this would look god on a HMMWV.
So I pressed some clay to the roof, pealed it away,
and used the clay as a pouring mold.
Once I had a resin cast I cleaned up the bottom of it,
glued a turret ring from a Stuart turret to it,
and added the CROWS ......................
then placed it on a HMMWV
I will do a few more casting of the hatch, cut it up and try to make,
a gunner's ring, with hatches.
The place to discuss anything relating to Military diecast, cars, planes, tanks and more...
1 post • Page 1 of 1
- Posts: 45
- Joined: Sun May 04, 2014 1:00 am
Who is online
Users browsing this forum: No registered users and 1 guest